Georgia mechanical / hvac changeout permit application
Nearly every jurisdiction requires a mechanical permit for a condenser, air handler, furnace, or full system changeout — even a like-for-like swap. The application is short, but the equipment data has to match the AHRI-rated combination on the invoice, or the inspector fails the final.
What goes on the Georgia version
- Equipment make, model and serial fields for the outdoor and indoor units
- BTU / tonnage and SEER2 or AFUE efficiency rating
- Job address, jurisdiction and property owner details
- Mechanical contractor license, insurance and bond block
Georgia jobs get the national baseline packet. Every field a building department needs is covered; state-specific attachments are being added market by market.
Mistakes that get it kicked back
- Listing the outdoor unit only — most inspectors want the matched indoor coil or air handler model as well
- Recording nominal tonnage instead of the rated capacity used for the efficiency certificate
- Filing before the equipment is confirmed in stock, forcing an amended permit when the model changes
Georgia metros
Get the Georgia filing checklist
One page: what a Georgia building department checks on this document, and the attachments that most often hold up issuance.
No account required. One email, unsubscribe any time.
General guidance for Georgia contractors, not legal advice. Confirm requirements with the authority having jurisdiction before filing.